KITE PRO Vision Bedienungsanleitung Seite 8

4.4.2 Donning Kite Pro Multivision
• Remove the protective film on both sides of the
lense.
•
Make sure all 3 comfort pads on the headband are
placed.
•
If needed adjust the headband height.
•
Switch the Kite Pro on by pressing the ON/OFF
button. After +/- 15 seconds a signal sounds to
confirm the correct function of the electronic
control unit
• Put the Kite Pro on the head and adjust the
headband by turning and pushing simultaneously
the adjustment wheel on the back.
• Fold the elastic face seal around the chin by pulling
the face seal backwards. Use the small tab to
facilitate.
• Warning: the face seal must be in full contact with
the skin around the face to give maximum
protection. Over time the face seal will lose its
elasticity and therefore it will not function
adequately. In doubt replace the face seal.
8