KITE PRO Vision Bedienungsanleitung Seite 14

• Fold the elastic face seal over the edge of the
welding helmet as shown in the picture. This will
facilitate mounting of the big screws.
• Mount the welding helmet and make sure the
square parts of the screws are placed correctly in
the square holes on the inside of the visor frame.
• Fold the elastic face seal back in its original
position
• After that, the result should be as shown in the
picture.
5.7.3 Replacement of lens and other parts of the
welding helmet:
•
See separate manual of Multivision Grind.
14