KITE PRO Vision Bedienungsanleitung Seite 12

•
Place a new face seal, turn the screws clockwise,
but do not over tighten
• After that, the result should be as shown in the
picture.
5.6.3 Visor
• The visor must be crystal clear without scratches
or cracks. In case of doubt exchange. The visor is
only available including the visor frame.
• Mount the new visor and make sure the square
parts of the screws are placed correctly in the
square holes on the inside of the visor frame.
• Warning: the elastic face seal must be on top of
the motor unit to prevent blocking the air outlet
on the exhaust side of the motor unit. See
picture.
.
12