Packing And Unpacking; Unpacking, Moving, Use And Storage; Setting To Work - Connection To The Power Supply - Nilfisk VHW320 Betriebsanleitung

VHW320 - VHW321 - VHW420 - VHW421 - VHW440 - VHW441

Packing and unpacking

Dispose of the packing materials in compliance with the laws
in force.
VHW320 MODEL
L - M - H
ATEX Z22
ATEX Z2
IC
VHW321 MODEL
L - M
H
ATEX Z21
ATEX Z22
ATEX Z2
VHW420 MODEL
STD
ATEX Z22
IC
C
VHW421 MODEL
L - M
H
ATEX Z21
GB
ATEX Z22
VHW440 MODEL
STD
IC
C
VHW441 MODEL
L - M
H
ATEX Z21
ATEX Z22
C393
Figure 3
A B C
(mm) (mm) (mm)
500 900 1360
500 900 1360
500 900 1360
500 900 1630
A B C
(mm) (mm) (mm)
500 900 1360
500 900 1360
500 900 1360
500 900 1360
500 900 1360
A B C
(mm) (mm) (mm)
620 1050 1660
620 1050 1660
620 1050 1950
620 1050 1950
A B C
(mm) (mm) (mm)
620 1050 1660
620 1050 1660
620 1050 1660
620 1050 1660
A B C
(mm) (mm) (mm)
620 1050 1660
620 1050 1950
620 1050 1950
A B C
(mm) (mm) (mm)
620 1050 1660
620 1050 1660
620 1050 1660
620 1050 1660

Unpacking, moving, use and storage

Operate on flat, horizontal surfaces.
The load-bearing capacity of the surface the vacuum cleaner is
placed on must be suitable for bearing its weight.
Setting to work - connection to the power
kg
supply
86
86
■ Make sure there is no evident sign of damage to the
91
vacuum cleaner before starting work.
■ Before plugging the vacuum cleaner into the
107
electrical mains, make sure the voltage rating
indicated on the data plate corresponds to that of
the electrical mains.
kg
■ Connect the plug into a socket with a correctly
installed ground contact/connection. Make sure that
91
the vacuum cleaner is turned off.
■ The plugs and connectors of the connection cables
96
must be protected against splashes of water.
99
■ Check that for proper connection to the electrical
mains.
91
■ Use the vacuum cleaners only when the cables
96
that connect to the electricity mains are in perfect
condition (damaged cables could lead to electric
shocks!).
■ Regularly check there are no signs of damage,
kg
excessive wear, cracks or ageing on the electric
cable.
121
121
153
When the device is operating, do not:
■ Crush, pull, damage or tread on the cable that
162
connects to the electrical mains.
■ Only disconnect the cable from the electrical mains
by removing the plug (do not pull the cable).
kg
■ Only replace the electric power cable with one of
the same type as the original: FROR, the same rule
136
applies if an extension is used.
■ The cable must be replaced by the manufacturer's
139
Service Centre staff or by equivalent qualified
personnel.
149
136
kg
134
165
175
kg
136
139
149
136
6
WARNING!
WARNING!