Ringing Tone; Key Tone; Roger Beep; Feedback Tone - Kenwood UBZ-LJ9SETE Bedienungsanleitung

4.5 Ringing tone

Ring tones help identify yourself to other participants and inform them of your call. 20 different signal
tones (CA01 - CA20) are available for this.
If each participant uses a different tone, the caller is easy to identify. The ringing tone is triggered by
pressing and holding the <PTT key> and then additionally briefly pressing the <Function key up>.
To change the settings, please proceed as follows:
• Press 5 x long on the <Function key up>, key and the current setting will flash on the display.
• The desired value (CA01 - CA20) can be set by briefly pressing the <Function key up> or
<Function key down> keys.
• Press the <PTT key> exits the settings menu and the transceiver is back in reception mode.
4.6 Key tone On / Off
If the key tone is activated, the transceiver gives an acoustic feedback when keys are pressed. You can
switch the key tone On or Off (KTOF / KTOn). To change the settings, please proceed as follows:
• Press 6 x long on the <Function key up>, key and the current setting will flash on the display.
• The desired value (KTOF / KTOn) can be set by briefly pressing the <Function key up> or
<Function key down> keys.
• Press the <PTT key> exits the settings menu and the transceiver is back in reception mode.
4.7 Roger Beep On / Off
The Roger Beep is a sound signal generated by the transceiver that is automatically transmitted at the
end of each transmission. This signals to the remote station that you have ended your call. You can
switch the Roger Beep On or Off (RBOF / RBOn). To change the settings, please proceed as follows:
• Press 7 x long on the <Function key up>, key and the current setting will flash on the display.
• The desired value (RBOF / RBOn) can be set by briefly pressing the <Function key up> or
<Function key down> keys.
• Press the <PTT key> exits the settings menu and the transceiver is back in reception mode.
4.8 Feedback Tone On / Off
The feedback tone is a tone generated by the transceiver that gives the sender of a ringing tone (see
point 4.5) feedback at its own device that the ringing tone is currently being heard at the remote
device by sounding the same tone at the same time at its own device. You can switch the feedback
tone on or off (FTOn / FTOF). To change the settings, please proceed as follows:
• Press 8 x long on the <Function key up>, key and the current setting will flash on the display.
• The desired value (FTOn / FTOF) can be set by briefly pressing the <Function key up> or <Func-
tion key down> keys.
• Press the <PTT key> exits the settings menu and the transceiver is back in reception mode.
14