OHAUS TD52 Bedienungsanleitung Seite 57

7. Fasten the USB Device Cover if you are using a USB Flash Drive
8. If you insert a Barcode Scanner or RFID cable, disassemble the cable gland by loosening the
cap nut and removing the rubber seal. Pass the cable through the cap nut; then spread the
rubber seal and place it over the cable. Now pass the cable through the body of the cable gland.
9. Put the rear housing back tn the front housing. Install the 6 sealing screws (Torque is
1.8N*m± 0.5). Insert the above cable through the housing and connect it to the board.
M25 Hole
USB Peripheral Cover
M25 Cable gland
Cap nut
Barcode Scanner cable
or RFID cable
DE-7