Herunterladen Inhalt Inhalt Diese Seite drucken

TMC REEF-Fill Compact Bedienungsanleitung Seite 7

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 13
MAINTENANCE
Caution: To avoid possible electric shock, special care should be taken when using
any electrical appliance near water.
Caution: Always isolate the REEF-Fill Compact System from the mains electricity before
installing or carrying out any maintenance.
1. Check regularly to ensure that the IR sensors, anti-siphon valve and pump are clean and free
of any dirt or detritus, salt and/or calcium deposits. Please note: We highly recommend
that this is checked at least once a week. Failure to do so could result in operating problems
and water overflowing from your sump or aquarium.
2. Regularly check to ensure all connections are tightly secured.
3. Test IR sensors by physically moving them in the water to ensure switch is operating
correctly.
OTHER THAN RE-MINERALISERS, WE DO NOT RECOMMEND THAT YOU
ADD ANYTHING (such as KH, Calcium or Magnesium supplements) TO THE RO
CHAMBER IN YOUR AQUARIUM SET UP. Precipitation of elements may damage
the REEF-Fill Compact pump.
TROUBLE SHOOTING
Problem: Pump not activating with low water levels
1. Possible Cause: No power.
Solution: Check connections and ensure IR Sensors and pump are connected to the
correct DC jacks.
Solution: Ensure IR Sensors are clean and working. Re-install in correct position, then turn
off and on again. Test components for correct activation. Check pump for damage or debris.
Problem: Pump constantly on
1. Possible cause: IR Sensor failure and or Smart Monitoring System unit error.
Solution: Ensure parts are clean and working. Re-install in correct position, then turn off
and on again. Test components for correct activation.
Problem: Pump activating with high water levels
1. Possible cause: Smart Monitoring System unit error and/or IR sensor error.
Solution: Ensure parts are clean and working. Re-install in correct position, then turn off
and on again. Test components for correct activation.
Problem: High and low water level alarms sound at the same time.
1. Possible cause: IR Sensors/Pump are not correctly connected
Solution: Check for correct connections.
5

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis