INSTRUCTIONS FOR INSTALLATION AND USE
Important Safety Information - Please Read Carefully
- Always isolate from the mains electricity before installing or carrying out any
maintenance to the REEF-Fill Compact system.
- Power to the REEF-Fill Compact system must be supplied through a Residual Current
Device (RCD) with a rated residual operating current not exceeding 30mA.
- To ensure the top up system functions correctly, the IR sensors, the anti-siphon valve and the
pump must be cleaned regularly to ensure they do not become clogged or covered with
debris or detritus.
- The IR sensors must always be installed correctly, with the IR water level monitoring sensor
(black cable) facing downwards and the IR water level monitoring safety sensor (white cable)
facing upwards. Failure to do so will result in operating problems and water overflowing
from your sump or aquarium.
- Pump rating: 12Vdc unless otherwise marked.
- Do not operate any appliance if it has a damaged cord or plug, if it is malfunctioning,
or if it has been dropped or damaged in any way.
- This unit is designed to be used indoors and is not suitable for any outdoor
applications.
- Ensure the REEF-Fill Compact System is safely positioned before operating.
- Install the Smart Monitoring System unit outside of the aquarium cabinet when
there is a sump present and away from any area where it may get splashed with
water.
- Always leave a drip-loop in the cables to prevent water running down the cable
and reaching the power source and controller (see below).
- Dispose of this unit responsibly. Check with your local authority for disposal
information.
Drip Loop
1