fadini DARDO 424 Montageanleitung Seite 22

DARDO 424 DARDO 424
RELEASE FOR MANUAL OPERATIONS
In the release mode, the operator does not perform any operation on the gate, in spite of voltage continuing to be supplied.
In this situation the gate can be opened and closed manually even if the operator is still mounted on to it.
The same coded key allows for the opening of the sliding protection cover and the manual overriding (Pic. 11).
IMPORTANT: to set the operator back to work, carry out the described steps in the reverse order.
1)
Insert the key and turn it
clockwise
3)
Turn the key anticlockwise,
then remove and put it
into the release device
seat
ADJUSTMENT OF THE MECHANICAL STOP PLATES (installations without ground gate stops)
Override the operator (see Pic. 11) so that it is disengaged from the gate, then open the gate by hand to the required position:
loosen the screw that fastens the stop assembly and position the plates so that the front fixing touches the assembly in the
required open (stop) gate position, then tighten the screw again (Pic. 12): the outer stop plate and its counterpart ie. the inner
plate must adhere firmly to the toothed bars. Carry out the same steps with the gate in closed position (Pic. 13).
IMPORTANT: eventually set back the operator to re-engage the gate (steps in Pic. 11 in reverse order).
Gate leaf
fully open
Gate leaf
fully closed
electromechanical operator for swinging gates
2)
Push the cover forward until open
Turn the key clockwise
4)
all the way until it stops
Gate fixing
Gate fixing
22
180° - half a turn
Loosen the screw and adjust the
position of the stop assembly (inner
and outer plates) to touch the gate
front fixing. The plates must mesh
the respective toothed bars into a
firm block. Tighten the screw hard.
Loosen the screw and adjust
the position of the stop
assembly (inner and outer
plates) to touch the gate
front fixing. The plates must
mesh the respective toothed
bars into a firm block.
Tighten the screw hard.
Pic. 11
Pic. 12
Pic. 13