Kress 650 SPS Originalbetriebsanleitung Seite 21

Operation
The wood fibres are thus pressed against the
stress corrosion protection 13 or 15 during saw-
ing, which prevents the edges being torn.
The area of application is limited to right-angled
(90°) cuts.
Dust suction
Insert the suction connection piece 9 into the saw
bench 4 from the back. The jigsaw can now be
connected to a commercially available vacuum
cleaner.
To keep the cut free of shavings, insert the flexible
suction hose into the opening of the suction con-
nection piece.
Digital electronic control
The stroke speed can be adjusted stepless from
500 spm to the maximum stroke rate of 3200 spm,
and thus adapted to the respective material requi-
rements. When under load, the digital electronic
control provides for more power. Regulation is
carried out via the speed control dial 2 at the front
of the handle.
Speed control range
Position 1
Position 6
The digital electronic control is provided with a
protection feature against restarting (no uninten-
ded starting, i.e. after a power outage or when the
mains plug has been pulled). This feature is for
your protection. The machine must be restarted
intentionally.
The motor can become overheated
as a result of sustained heavy usage
and low speeds.
Changing the tool
Disconnect the plug from the power
source before making any adjust-
ments, changing accessories, or stor-
ing power tools.
Such preventive safety measures
prevent accidental start of the power
tool.
min. stroke rate
approx. 500 strokes/min
max. stroke rate
approx. 3200 strokes/min
Wear safety gloves for tool chang-
ing.
The tool insert can become very hot
after working for long periods and/or
the cutting edges of the tool insert
are sharp.
Clamping and unclamping
blades
The advantage of the clamping system is that saw
blades can be changed without tools.
First push the cover 3 up. Turn the tension lever 6
to open the quick-change clamping system so that
the saw blade 8 can be inserted. Make sure that it
is pushed back as far as it can go.
By releasing the tension lever 6 and then push-ing
in the direction of the tappet, it is automatically
fixed in position, and the tension lever 6 returns to
the neutral position.
When unclamping the saw blade 8, it is released
from the fixed position by turning the tension lever
6. It can then be removed from the tappet. The
protection roller, which prevents the saw blade
from moving and serves to unburden the mechan-
ical parts (tappet), automatically produces a
clamping angle of 90° as a positive stop. Natural-
ly, this only applies when original saw blades are
used.
-WARNING-
Press jigsaw against saw blade tip on wooden
board, until clamping lever 6 springs back to its
starting position.
It is only by doing this that the secure clamping of
the saw blade 8 can be ensured and the hood 3
can be closed.
-NOTE-
Check the tight seating of the saw blade.
A loose saw blade can fall out and lead to inju-
ries.
English 21
EN
the saw
SPS-EN / 0912