Kress 650 SPS Originalbetriebsanleitung Seite 19

Operation
Noise/vibration Information
Noise levels
Measured values determined according to
EN 60 745.
Typically the A-weighted noise levels of the ma-
chine are:
sound pressure level (L
sound power level (L
wA
Measurement uncertainty K=3 dB
The noise level can exceed 85 dB(A)
during operation.
Wear ear protection!
Vibration
Triaxial vibration emission level determined in ac-
cordance with EN 60745.
Jig Saw
Cutting wood; a
m/s²
Measurement uncertainty K
m/s²
Cutting sheet metal; a
m/s²
Measurement uncertainty K
m/s²
The vibration emission level given in
this information sheet has been
measured in accordance with a
standardised test given in EN 60745
and may be used to compare one
tool with another.
The vibration emission level will vary because of
the ways in which a power tool can be used and
may increase above the level given in this infor-
mation sheet. This could lead to underestimation
of vibration when the tool is used regularly in such
a manner.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given
period of work should also take into account the
times when the tool is switched off and when it is
running but not actually when doing the job.
This may significantly reduce the exposure level
over the total working period.
) 84 dB (A)
pA
) 95 dB (A)
650 SPS
:
h
:
h
4. Operation
Before carrying out any work on the
machine, pull the mains plug.
Putting into operation
Observe correct main voltage!
Before putting into operation, check that the mains
voltage and frequency on the identification plate
match the details of your mains supply.
 Connect mains cable module
If using an extension cable: Only use
extension
approved for the application with the
required cross-section. Otherwise the
power of the tool can be reduced and
the cable can overheat. Replace
damaged cables.
9,5
Mains cable
1,6
If the mains cable is damaged while
working, pull the mains plug immedi-
9,3
ately.
1,6
Mains cable module
Mains cable module with Patent
Quick Interlock.
Connect the mains cable module 12 to the handle.
The plug must snap in.
Use the mains cable module 12 only for Kress
electric tools. Do not attempt to operate other ma-
chines with the module.
Damaged mains cable modules must not be used.
They must be replaced by a new Kress mains ca-
ble module immediately.
Push the two unlocking buttons 13 and remove
the mains cable module 12 from the handle.
Use only an original Kress mains cable module
and at least a heavy rubber tube cable (H07RN-
F).
English 19
cables specifically
SPS-EN / 0912
EN