Putting Into Operation; Mains Cable - Kress 1200 SPE Originalbetriebsanleitung

18 English
Noise/vibration information
Noise levels
EN
Measured values determined according to
EN 60 745.
The average A-weighted noise level of the tool is:
Sound pressure level (L
Sound power level (L
Measurement uncertainty K = 3 dB
The noise level can exceed 85 dB(A)
during operation.
Wear ear protection!
Vibration
Triaxial vibration emission value, measured in ac-
cordance with EN 60745.
Sabre saw
The vibration emission level given in
this information sheet has been
measured in accordance with a
standardised test given in EN 60745
and may be used to compare one
tool with another.
The vibration emission level will vary because of
the ways in which a power tool can be used and
may increase above the level given in this infor-
mation sheet. This could lead to underestimation
of vibration when the tool is used regularly in such
a manner.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given
period of work should also take into account the
times when the tool is switched off and when it is
running but not actually when doing the job.
This may significantly reduce the exposure level
over the total working period.
SaebelS-EN / 0812
) 90 dB(A)
pA
) 101 dB(A)
wA
1200 SPE
Sawing wood; a :
h
m/s²
Measurement uncertainty K
m/s²
4. Operation
Before carrying out any work on the
machine, pull the mains plug.

Putting into operation

Observe correct main voltage!
Before putting into operation, check that the mains
voltage and frequency on the identification plate
match the details of your mains supply.
If using an extension cable: Only use
extension
approved for the application with the
required cross-section. Otherwise the
power of the tool can be reduced and
the cable can overheat. Replace
damaged cables.
24.6

Mains cable

10.9
If the mains cable is damaged while
working, pull the mains plug immedi-
ately.
Fixed power supply
Fixed power supply
Damaged mains cables must not be used. They
must be replaced immediately by an expert tech-
nician.
Operation
Switching on and off
Press or release 1 the On/Off switch.
Changing the cutting rate
The cutting rate of the power tool when it is
switched on is infinitely variable, depending on
how far you press in the On/Off switch 1.
Operation
cables specifically