Maintenance And Servicing; Maintenance And Cleaning - Bosch Intuvia 100 Benutzerhandbuch

English – 2
doing so, be aware of the torque specified on the adapter
tray (2).
Connect the connection cables that come out of the drive
unit and the control unit. It does not matter which cable is
connected to which connection for the functions to work.
When connecting the cables, ensure that the markings on
the connector and on the cable match.
Securing on the handlebars (see figure C)
Note: The display holder must only be secured in the cyl-
indrical area of the handlebars and not in the tapered area.
To clamp a display in the centre, the handlebars must have a
cylindrical area of at least 90 mm in width.
Open the clamp and bring the 1-arm socket (6), together
with the round rubber spacer (5), into the required position.
Gently tighten the clamp screw (4) so that the 1-arm
socket (6) can still move.
Adjust the tilt for the display mount by loosening and tight-
ening the screw (7). Preferably adjust the tilt without the
display or on-board computer.
In the connection between the 1-arm socket (6) and the ad-
apter tray, there are interlocking teeth, which means that it
is only possible to align the adapter tray in predefined posi-
tions. Before tightening the screw (7), make sure that the
teeth engage in one another correctly. In addition, be aware
of the torque specified on the 1-arm socket (6).
Bring the 1-arm socket (6) into its final position and tighten
the clamp screw (4). Be aware of the torque specified on the
1-arm socket (6) here too.
Thanks to the round rubber spacer (5), it is possible to move
the 1-arm socket (6) in all directions.
Removal blocker
A device attached to the display holder can be secured using
the removal blocker (8). Usage is described in the operating
instructions for the respective device.

Maintenance and servicing

Maintenance and cleaning

The display holder must not be cleaned with pressurised wa-
ter.
Use a soft cloth dampened only with water for cleaning. Do
not use cleaning products of any kind.
Have all repairs performed only by an authorised bike
u
dealer.
After-sales service and advice on using products
If you have any questions about the eBike system and its
components, contact an authorised bicycle dealer.
For contact details of authorised bike dealerships, please
visit www.bosch-ebike.com.
0 275 007 3S1 | (09.06.2021)
Disposal
The drive unit, on-board computer incl. operat-
ing unit, battery, speed sensor, accessories
and packaging should be disposed of in an en-
vironmentally correct manner.
Do not dispose of eBikes and their components with house-
hold waste.
In accordance with Directive 2012/19/EU
and Directive 2006/66/EC respectively, elec-
tronic devices that are no longer usable and de-
fective/drained batteries must be collected
separately and recycled in an environmentally
friendly manner.
Please return Bosch eBike components that are no longer
usable to an authorised bicycle dealer.
Subject to change without notice.
132
Bosch eBike Systems