Care And Maintenance; Cleaning The Housing; Cleaning The Filters - hanseatic HAP35060WKC Gebrauchsanleitung

Care and maintenance

WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
■ Before cleaning the appliance and
the fi lters, pull the mains plug out of
the socket.
■ Ensure that no water seeps into the
appliance.
■ Never immerse the appliance in wa-
ter.
■ Only insert the mains plug into the
socket if all appliance components
are completely dry.
NOTICE
Risk of damage!
Improper cleaning of the appliance can
impair the surface.
■ When cleaning the appliance, do not
use any scouring, solvent-based or
abrasive cleaners (e.g. oven or grill
spray) or cleaning utensils such as
scouring pads or similar.

Cleaning the housing

1. Switch off the appliance and take the
mains plug out of the socket.
2. Wipe the appliance surface off with a
lightly moistened cloth. Use a small
amount of washing-up liquid for stubborn
soiling. Make sure that no liquid gets into
the appliance.
3. Thoroughly dry all parts after cleaning.
Care and maintenance

Cleaning the filters

NOTICE
Risk of damage!
Improper handling of the fi lters can
lead to property damage.
■ Never use water or another liquid to
clean the fi lters.
■ Clean the fi lters very carefully and do
not apply high pressure.
Cleaning the H13 filter (7)
To extend the service life of the H13 filter, it
should be cleaned every 2 weeks.
1. Switch off the appliance and take the
mains plug out of the socket.
2. Remove the H13 filter (7) from the ap-
pliance (see "Remove filter packing" on
page EN-10).
3. Place the H13 filter (7) on an old newspa-
per, sheeting or similar.
4. Remove any dust stuck to the appliance
with the brush or crevice nozzle on a vac-
uum cleaner. Do not apply high pressure
as this may damage the filter.
5. Then replace the H13 filter (7).
6. Insert the filter cover (6) at the bottom and
fold it closed.
Cleaning the Activated Carbon filter (8)
Clean the Activated Carbon filter (8) once a
month.
1. Switch off the appliance and take the
mains plug out of the socket.
2. Take both filters out of the appliance (see
"Remove filter packing" on page EN-10).
3. Leave the Activated Carbon filter to dry
for 2–3 hours in a sunny, well-ventilated
place.
4. Then clean the front and back of the fil-
ter with the brush or crevice nozzle on a
vacuum cleaner. Do not apply high pres-
sure as this may damage the filter.
5. Then replace both filters.
6. Insert the filter cover (6) at the bottom and
fold it closed.
Page EN-13