Mill SG2000MEC Bedienungsanleitung Seite 5

• The heater must not be used if either the cord or plug
is damaged. The heater must not be used if it has been
dropped on the floor or is damaged in any other way caus-
ing it to malfunction.
• The cord must be repaired by the manufacturer or by an ex-
pert if it has been damaged, to avoid dangerous situations.
• Avoid using extension cords, which may overheat and
could possibly start a fire.
• Never cover the air vents on the heater. Avoid potential fire
hazards by making sure the air intakes are not blocked or
covered. The heater should be used in rooms with normal
flat floors.
• The heater should not be installed in close proximity to
flammable materials of any kind because there can always
be a risk of fire.
• The heater must never be used in rooms where gasoline,
paint or other flammable liquids are stored, such as in a
garage.
• Never touch an electric heater with wet hands. The heater
should be installed so a person showering or taking a bath
cannot come into direct contact with it.
• Some parts of this product can become very hot and cause
burns. Particular attention has to be given where children
and vulnerable people are present.
• The heater must be switched off, the plug removed and the
heater must cool down before it is moved.
• Avoid overloading the mains (the circuit) where the heater
is connected. The heater may overload the electrical circuit
if other electrical devices are plugged into the same socket
outlet.
3