Instructions Electronic Thermostat; Usage Electronic Thermostat - Mill SG2000MEC Bedienungsanleitung

Instructions electronic thermostat

Please see table on page 4 for which models that have electronic thermostats.
Control panel
See figure 5 on separate illustration sheet
1. Thermostat, output selector and timer button (applies to CO2200LEDMAX only):
i. Turn the selector to the left to decrease the temperature, and turn the selector to
the right to increase the temperature.
ii. Push the button to change the desired power level. 3 power levels.
iii. Press and hold the button for 3 seconds to activate the timer function, and
choose number of hours 0-24 you wish to have the timer function activated
2. Fan ON/OFF (does not apply to CO2200LEDMAX)
3. ON/OFF button
4. Power indicator — Shows whether the heater is using power or not
5. Indicates the output level
6. Indicates whether the fan is activated / timer indicator for CO2200LEDMAX
7. Desired room temperature
8. Standby indicator for CO2200LEDMAX
WARNING: BE SURE THE FOOT IS FITTED CORRECTLY AND ACCORDING TO THE
INSTRUCTIONS BEFORE USING THE HEATER!
ATTENTION! This heater is only meant to be used as a supplementary heating source, and
must not be used without supervision

Usage electronic thermostat

1. Plug the heater into a grounded outlet.
2. Press the ON/OFF button.
3. Choose the desired power |, || or |||, by pressing the output selector. Turn the ther-
mostat to the desired temperature while looking at the display. As soon as the room
temperature drops below this level, the heater will automatically start again. When
the room has reached the desired temperature again, the heater will turn itself off.
4. The thermostat goes from 5 to 35°C.
5. If you want to change the temperature in the room, repeat step 3.
6. Press the fan button to start the fan (does not apply to CO2200LEDMAX).
the fan is only active when the heater is heating up
is on).Timer function for CO2200LEDMAX: Press and hold the timer button for 3
seconds to activate the timer function, 00 will appear in the display. Turn the timer
button to select how many hours 0-24 you want the timer function to be activated, 0
means no timer function. Aer selecting the number of hours, press the timer button,
or wait 15 seconds for automatic confirmation. The timer indicator will now light up.
When the timer function is o, the heater goes to standby mode, the display shows
OF and the standby indicator will light up.
Note that
(when the power indicator
7