Working Advice - Bosch AFS 23-37 Originalbetriebsanleitung

Action
Connecting the extension cable
Switching On and Off

Working advice

Cleaning
Cutting line storage
Selecting accessories
Troubleshooting
Problem Possible Cause
Product does not run Power turned off
Mains socket faulty
Extension cable damaged
Fuse faulty / blown
Thermal cut out
Product runs intermit- Extension cable damaged
tently
Internal wiring of product defective
Product does not cut Cutting blade/line damaged
Increased vibrations Cutting blade damaged
Cutting line broken
Debris build-up on cutting head
Blade nut loose
Cutting blade incorrectly mounted
Poor cutting result and Grass too high/dense
remaining plant
stumps
Cutting blade blunt
Cutting blade obstructed
Debris build-up on cutting head
Cutting blade nut can- Damaged thread on nut/shaft
not be unscrewed
Locking pin not located correctly
Cutting blade fails to Cutting blade obstructed
rotate
Bosch Power Tools
Figure Page Working Advice
I 190
Application area
J 191
Clearing shrubs/brushes
K 191
Cutting saplings
L 192
Trimming/thinning
M 193
Clearing weeds
N 193
Cutting long grass
Clearing nettles
Cutting tool
Blade
Blade
Line
Line/blade
Line
Line/blade
Corrective Action
Turn power on.
Use another socket.
Inspect cable, replace if damaged.
Replace fuse.
Allow product to cool and try again.
Inspect cable, replace if damaged.
Contact Bosch customer service agent.
Contact Bosch customer service agent.
Replace cutting blade/line (always wear protect-
ive gloves).
Replace cutting blade (always wear protective
gloves).
Replace line.
Clean cutting head and remove debris.
Tighten cutting blade nut to 20 Nm, ensuring the
cutting blade, running plate and thrust washer are
mounted centred (always wear protective
gloves).
Loosen cutting blade and mount it centred. Ob-
serve guide rings on the cutting blade to ensure
centred alignment.
Grass too high: Cut in stages.
Grass too dense: Reduce cutting rate per cut.
Flip/replace cutting blade
Check bottom side of product and clear out as ne-
cessary (always wear protective gloves).
Clean cutting head and remove debris.
Lubricate shaft to aid removal.
Reinsert locking pin and apply light pressure
whilst rotating shaft.
Check bottom side of product and clear out as ne-
cessary (always wear protective gloves).
F 016 L94 421 | (03.05.2022)
English | 13