Mounting And Operation; Battery Charging; Working Advice - Bosch AHS 45-15 LI Originalbetriebsanleitung

OBJ_BUCH-1685-003.book Page 15 Monday, December 15, 2014 9:57 AM

Mounting and Operation

Action
Delivery Scope
Inserting the Battery
Starting
Stopping

Working Advice

Blade Maintenance
Storage and Transport
Selecting Accessories

Battery Charging

Charging Procedure
The charging procedure starts as soon as the mains plug of
the battery charger is plugged into the socket outlet and the
battery is inserted into the charging compartment.
Note:
The charging procedure is only possible when the battery
temperature is within the allowable charging temperature
range, see "Technical Data" section.
Flashing Battery Charge Indicator
The charging procedure is signalled by a
flashing battery charge indicator.
Troubleshooting
Problem Possible Cause
Hedgecutter does not op- Battery discharged
erate
Safety switch not activated correctly
Hedgecutter operates in- Internal wiring of machine damaged
termittently
On/Off switch defective
Motor reverses repeatedly then stalls after 3 s. see "Working Advice" (Anti Blocking)
Motor runs but blades re- Internal fault
main stationary
Cutting blade hot Cutting blade blunt
Cutting blade has dents
Too much friction, due to lack of lubricant
Blade will not move Battery discharged
Machine defective
Excessive vibrations/ Machine defective
noise
Bosch Power Tools
Continuous Lighting of the Battery Charge
Indicator
Figure Page
1 220
2 220
in the allowable charging temperature range, and cannot be
3 220
charged for this reason. The battery is charged as soon as the
4 221
allowable charging temperature range is reached.
When the battery is not inserted, continuous lighting of the
5 221
battery charge indicator indicates that the mains plug is in-
6 222
serted in the socket and that the battery charger is ready for
operation.
6 222
7 222
Working Advice
 Hold the garden product away from yourself. Stand in a
secure and stable position.
 When storing the product, do no store it hanging on the
front handle or switch.
Anti Blocking
If the blade stalls on a tough material, the load of the motor in-
creases. The intelligent micro-electronics senses this over-
load condition and repeatedly reverses the motor, in order to
prevent stalling and to cut the material through.
This audible reversing cut action continues for up to 3 s.
After cutting through, the garden product continues in its nor-
mal mode, or in case the overload condition continues the
blades automatically stop in the open position (e. g. in case a
piece of metal fence accidentally blocks the garden product).
Continuous lighting of the battery
charge indicator indicates that the
battery is fully charged or that the
temperature of the battery is not with-
Corrective Action
Recharge battery; also see "Battery Charging"
see "Mounting and Operation" for correct use
Contact Service Agent
Contact Service Agent
Contact Service Agent
Have blade sharpened
Have blade inspected/overhauled
Apply lubricant spray (1 609 200 399)
Recharge battery; also see "Battery Charging"
Contact Service Agent
Contact Service Agent
F 016 L81 220 | (15.12.14)
English | 15