General Condition; Signs/Labels; Design; Hinges/ Bearings - Novoferm NovoDock L340 Original-Montage- Und Betriebsanleitung

8.2

General condition

• Carry out a test run and make sure to test all
operating functions:
– lifting
– folding out the hinged lip
– lowering
– floating position
– moving back to the resting position
– emergency off function via main switch
• Check these options, if available:
– automatic return to the resting position
– locking of door/dock leveller (sensor) or safety
wheel chock
– warning signal system (optical/acoustic)
• Carry out a visual inspection on:
– mechanical damages, rust formation and the
condition of the welded construction
– dirt and oil spills in the area underneath the
dock leveller. Remove any if present.
• Make sure that no debris, stones etc. obstruct the
function of the hinges.
• Provide sufficient slip resistance by keeping the
dock leveller platform clean and dry.
• Do not use any aggressive cleaning agents or
thawing salts! Risk of corrosion:
• Do not aim a high-pressure water jet at the
control system, the hydraulic system or any
electrical connections!
If you notice damages the dock leveller must be in-
spected by an expert/ a qualified person and must not
be used until the repair work has been completed.
Fig. 6: Lubrication points, illustration may deviate from the product
These assembly, operation and maintenance instructions must be kept for the entire period of use!
8.3

Signs/labels

Check the signs/labels for completeness, legibility
and condition according to chapter 3.3 and 3.4. La-
bels/rating plate must be replaced as required.
8.4

Design

Carry out a visual inspection of the entire steel con-
struction with regard to the following:
• mechanical damages to the weld seams
• completeness and tightness of the safety
elements and screw connections
• deformations and corrosion
• condition of the connection to the installation
point
Carry out the following checks on condition and func-
tion:
• slip resistance condition of the drivable surfaces
• condition of the anti-slip coating/sound-absorbing
coating (optional) of the dock leveller platform
• protective plate
• maintenance support
• screw connection and safety cotter pins of the
hydraulic cylinders
• safety cotter pins at the cross rod
• all moving parts for ease of movement
If necessary, have the design inspected by an expert/
a qualified person.
8.5

Hinges/ bearings

Lubricate the bearings on the dock leveller platform
through the tapered holes and the bearings of the lift-
ing cylinders with multi-purpose grease (see arrows).
EN - 39