Maintenance - Hyundai EM 7301 Bedienungsanleitung

COFFEE MACHINE COOLING DOWN (AFTER USING THE STEAM JET)
If selector A1 will be turned to „ " after using the steam jet, buttons B3 and B4 will be
flashing quickly, thus informing that the temperature of the interior coffee machine system
is too high for coffee preparation. Allow it to cool down by pressing B5 (hot water function)
twice and quickly. Flowing water will cause the interior system to cool down.
INDIVIDUAL SETTING OF THE AMOUNT OF COFFEE
The amount of coffee can be modified for 1 or 2 cups (using buttons B3 and B4). For both
buttons, water quantity can be adjusted, ranging from 30 to 150 ml. The procedure is as follows:
1. Switch on the coffee machine by pressing button B1 and wait for it to warm up.
2. Place the cup/cups of adequate volume below the coffee outlet.
3. Choose the relevant button (B3 or B4). Press and hold it until the required coffee
volume has been dispensed. Then release the button (sound signal will be generated).
In this manner, the new coffee volume for B3 or B4 will be stored.
4. This amount will remain stored even if the coffee machine has been disconnected from
the mains.
Note
Press and hold buttons B3 and B5 simultaneously for approx. 3 seconds to delete pre-set
amount of coffee. Illuminated buttons B3, B4 and B5 will flash several times, then the
coffee machine will be switched off. Factory setting will be restored.
HOT WATER FUNCTION
Method 1:
1. Press B1 to turn on the coffee machine.
2. Wait for the coffee machine to warm up sufficiently (the light on all buttons is
permanently on).
3. Press B5 twice quickly.
4. Hot water will be flowing from outlet A6 for approx. 8 seconds.
Method 2:
1. Press B1 to turn on the coffee machine.
2. Wait for the coffee machine to warm up sufficiently (the light on all buttons is
permanently on).
3. Turn knob A1 to „
4. Hot water will be flowing from outlet A3.
5. After completion of this function, turn selector A1 to „ ".
V. MAINTENANCE
Unplug the appliance from power supply by taking the fork of the power cord
out of the socket (except for operations which require the coffee machine to
remain switched on)! Clean the appliance only when it is cooled down! Don't use
a dish-washer nor rough and aggressive detergents (for example, sharp items,
scrapers, diluent or other dissolution reagents)! Wipe the surface of the appliance and
its inlet with a damp cloth.
IMPORTANT
Regularly inspect and clean all parts to prevent mould on coffee residues!
".
37 / 59
EN