Using The Appliance - Hyundai EM 7301 Bedienungsanleitung

Removing operational components
Looking at the camera that is used more often with the coffee machine (aluminium lever C,
water tank D, drip tray E, coffee bean container F3), proceed as shown in Fig. 1. Proceed
in reverse order to put the components back.
Rinsing the coffee maker
At the first start-up or if you have not used the coffee machine for more than 2 days, flush
it using the following procedure:
1. Fill tank D with water up to the MAX mark.
2. Place lever C and the stainless-steel bowl (C1/C2) on the coffee machine as shown in
Figure 2.
3. Connect the machine to the mains. Make sure that the rotary knob A1 is in the „ " position.
4. The coffee machine must be switched on by pressing B1 button (all buttons will flash
and sound signal will be given).
5. Wait for the coffee machine to warm up sufficiently (illuminated buttons B3, B4 and B5
will be flashing during the heating phase, then all illuminated buttons will be lighting).
6. Place a suitable vessel of sufficient volume below the coffee outlet or use 2 bigger cups
which will be alternated in the course of rinsing, emptying the water in the cups.
7. Make several cups (without coffee) using buttons B3/B4). We recommend rinsing the
coffee machine 3 to 5 times using this procedure.
NOTICE
When rinsing, the coffee machine produces hot water.
IV. USING THE APPLIANCE
Remarks
– After connection of the appliance with the electric mains, sound signal will be heard and
illuminated buttons will flash several times.
– Heating up time of the coffee machine will be indicated by flashing illuminated buttons
B3, B4 and B5. After warming up, the light on all buttons is continually on.
– The coffee brewing can be stopped at any time by pressing the corresponding B3/B4 button.
– When the coffee brewing is on, the A1 knob must be in the „ ", position, otherwise the
coffee brewing function cannot be switched on.
COFFEE GRINDING
1. Make sure there are coffee beans in the F3 container.
2. Switch the coffee machine on by pressing the B1 button (make sure that the A1 knob is
in the „ " position).
3. Use button B2 to select dish size for one cup (B2 is not lighting) or two cups (B2 is
lighting). When required, adjust the coffee quantity using selector B6 (depending on
grind size and dish size).
4. Place dish (C1/C2) into lever C and insert the lever into holder F1 so that button F2 will
be pressed, thus starting the grinder. Now you can adjust the required grind size using
selector switch F6 (Fig. 3).
5. Wait until the grinding is completed. The grinding process can be stopped any time by
pressing B2.
Remark
When grinding coffee beans, set selector switch B6 to the initial position „
Only when you can see, how much coffee has been ground, increase or adjust the coffee
quantity using B6 as required.
35 / 59
EN
" (Minimal).