Before Commissioning; Assembly; Commissioning; Maintenance - Scheppach 3906301915 Originalbetriebsanleitung

Pressure difference
Filter area of filter bag
Sawdust bag volume
Engine output
Electric motor
Rated input P1
Power output P2
Motor speed
Workplace emission values
No-load noise
Operating noise

6. Before commissioning

• After unpacking check all parts for transport dam-
age. In the event of complaints the carrier must be
informed immediately. Later claims will not be rec-
ognised.
• Check whether the shipment is complete.
• Familiarise yourself with the product by means of
the operating instructions before using for the first
time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Replace-
ment parts can be obtained from your scheppach
dealer.
• When ordering please provide our article number
as well as type and year of manufacture for your
equipment.
m Attention!
The device and the packaging material are not chil-
dren's toys! Do not let children play with plastic
bags, films or small parts! There is a danger of
choking or suffocating!
7.

Assembly

For packaging reasons, your machine is not completely
assembled.
• Attach the side covering loosely to the base frame
using flat-head screws M8 x 40 mm and screw nuts.
Do not tighten completely. fig. 2, 3
• Attach the cross member to the side covering left
and right with flat-head screws M 8 x 12 and screw
nuts. fig. 4, 5
• Remove all screws and nuts from the housing.
1600 Pa
• Attach the housing to the side coverings using flat-
head screws M5 x 20 and screw nuts. Securely tight-
approx. 1 m
2
en all nuts. fig. 6
75 l
• Slide the clamping strip through the loops on the fil-
ter bag and fix the filter bag on the container. fig. 7
• Position the support bar into the housing and hang
230 V/50 Hz
the filter bag from it. fig. 1
0.55 kW
• Attach the sawdust bag to the lower air ventilator us-
0.34 kW
ing the clamping strip. fig. 7
2850 1/min • Attach the extraction hose to the nozzle on the hous-
ing and affix it with a hose clamp. fig. 8
• Attach the hose coupling to the other end of the hose
75.5 dB (A)
using a hose clamp. fig. 9
75.5 dB (A)
The extraction system should be cleaned every time
the sawdust bag is changed.
Damaged filters and bags must be immediately
changed in order to keep the amount of dust that es-
capes into the work environment as low as possible.

8. Commissioning

Attention!
Always make sure the device is fully assembled
before commissioning!
Observe the safety instructions before the commis-
sioning. The data on the motor type plate (voltage and
frequency) must match the mains voltage and frequen-
cy.
After connecting to the mains, the extraction system is
ready for operation.
9.

Maintenance

For all maintenance and cleaning work, turn off the mo-
tor and pull out the mains plug.
• Installation, repairs and maintenance work on the
electrical equipment may only be carried out by
electricians.
• For constant performance, periodically shake out
filter bag vigorously. Between cleanings, beating the
bag with the hand several times is sufficient.
• The sawdust bag must be replaced at the latest
when the sawdust is within 10 cm of the housing
collar.
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
www.scheppach.com GB | 17