Troubleshooting Guide; Warranty And Service - Braun CareStyle 7 Bedienungsanleitung

When the system needs to be decalcified the
FastClean icon (3) turns permanently on.
To perform the descaling take the following
steps:
Switch off (1) and unplug the appliance.
z
Empty the water tank.
z
Wait until the appliance has cooled down
z
(minimum 2.5 hours).
Place the appliance on the edge of the sink
z
and turn the closure (10) anticlockwise to
open it. Let the water flow into the sink.
Clean the closure under running water to
z
remove the scale formations.
When no more water comes out of the
z
appliance screw the closure clockwise to
close the boiler.
Plug in and switch on.
z
Press the FastClean system button (3) for
z
2 seconds to reset.
If the appliance is switched off without
descaling, the FastClean icon (3) turns
permanently on again when it is next
switched on.
Note: Because of the different water
composition by using an installed in-house
permanent descaler, it is recommended to
descale the system after every 4 complete
refills or at least once per month.
Please note that in this case the FastClean
icon will not automatically turn on.
(G) After ironing
Care & Cleaning
After every ironing session remove and
empty the water tank.

Troubleshooting Guide

Problem
The appliance does
not switch on.
16
Cause
The appliance is not
plugged into a mains
socket.
Before cleaning, always make sure that
z
the appliance is switched off, unplugged
and has cooled down completely.
To clean the soleplate and the soft
z
material on the handle it is suggested to
use a damp cloth.
Never use chemicals, vinegar or scouring
z
pads (eg. sponges with coarse nylon
fabrics etc).
Lock system
The appliance is equipped with a lock
system for convenient transportation and
easy storage. It is possible to lift and carry
the appliance on the handle of the locked
iron.
Note: Before transportation make sure the
iron is properly locked and the water tank is
empty.
Place the soleplate into the recess on the
z
iron mat.
To lock the iron push the slider (8) (easy
z
lock) toward the iron until you hear a "click".
To unlock the iron push down the button
z
on the slider (easy lock). The iron will be
released.
Storage
Unplug, empty the water tank and let the
appliance cool down before winding the
cords for storage.
For a convenient storage of the power cord
also refer to „Ergonomic Certification".

Warranty and Service

For detailed information see separate
warranty and service
www.braunhousehold.com.
Solution
Make sure the appliance is
correctly connected and press
the On/Off button.
leaflet or visit