Sanremo TREVISO Bedienungsanleitung Seite 17

ENGLISH
3)
In the TREVISO LX and TREVISO LX
and to the appliance; if the mains water pressure exceeds 6 bar a pressure reducer must be installed to regulate the outlet pres-
sure to a maximum of 6 bar.
N.B. Version TREVISO LX – TREVISO LX 1500W: a water softener is indispensable for correct appliance operation, best coffee in the
cup and long life of the components, since it removes lime and residues from the water that would otherwise shorten their life.
The company is relieved of all and any liability in the event of failure to comply with the above instructions.
Preliminary check
Before using the appliance, check that:
-
the plug is inserted properly into the mains power outlet.
-
In the TREVISO LX and TREVISO LX
the water tap is open; also check for leaks.
With the steam tap (H) open, put the on/off switch (C) to the ON position and wait for the water in the boiler to reach the maximum
level set by the electronic control.
Wait for steam to come out the steam nozzle (H), then close the tap and, using the boiler pressure gauge, check that the pressure
has reached and maintains a value of 0.8:1 bar. If it is not on this value, turn the adjusting screw on the pressure switch (+increase,
- decrease).
Hot water
To dispense hot water, make sure that the boiler pressure gauge indicates a pressure of 0.8
clockwise.
Take great care as there is a risk of scald burns.
Steam
Swivel steam nozzle. To dispense steam, just turn the knob (H) counter-clockwise. Take great care as there is a risk of scald
burns.
Coffee
Insert the filter-holder (E) into the group head (D) turning the filter-holder counter-clockwise. Raise the lever (L), wait for the required
quantity of coffee to be dispensed and then lower the lever (L) to its original position.
Filter: After having dispensed the last cup of coffee the filter and filter-holder must be washed with water. If they are damaged, worn
or clogged, they should be replaced.
Drip tray and grid: The drip tray and grid should be removed frequently and coffee residues cleaned away.
Water softener: TREVISO LX – TREVISO LX 1500W the softener should be periodically regenerated according to the manufacturer's
directions given in the instruction booklet.
External housing: The external housing and the steel parts should be cleaned with sponges and soft cloths to avoid scratching. Only
use detergents that do not contain abrasive powders or solvents and do not use steel wool.
WARNINGS: when using the appliance it is recommended that the various instruments be kept under control, checking that they are
in the previously indicated normal working conditions.
The user must check that this is not due to:
-
power failure or blackout
- Version TREVISO LX – TREVISO LX 1500W no mains water supply or no water inside the boiler.
- For the TREVISO (Vibration pump) version, ensure that there is water in the container.
For any other causes, contact a qualified SAN REMO After-Sales Service Centre.
BEFORE CARRYING OUT ANY WORK INSIDE THE APPLIANCE OR REMOVING ANY PART OF THE HOUSING, ALWAYS DISCONNECT FROM THE
ELECTRICAL SUPPLY.
version connect the hose to the mains water supply and then to the water softener
1500W
USE
version, the filling hose is correctly connected to the mains water outlet and that
1500W
CLEANING
APPLIANCE MALFUNCTION
17
÷
1.3 bar. Turn the tap knob (B) counter-