clage Zip HydroTap G5 BCS 20 Gebrauchsanleitung Seite 38

LCD Screen Operation - Section B
Power Pulsing Mode
To ensure that the hot water is kept as close as possible to the set-
point, the tolerances for temperature fl uctuations are reduced.
VII. Advanced Settings II (Touch-Free only)
ADVANCED SETTINGS 2
Wave Tap Sensor Demister Mode
Allows Control of Heating of Wave Tap
Wave Tap Lock Mode
Dual Sensors Required for Chilled/Sparkling
Touch-Free Lock Mode
When the mode is active, the rear safety sensor must also be activat-
ed for cold water and sparkling water in addition to the water sensor.
This prevents malfunctions, e.g. due to refl ective surfaces near the
tap.
The fi lling function is no longer available when the function is active.
VIII. System Restart
Touch-Free Sensor Demister
12:12 PM
The heating prevents the sensors
from fogging up due to escaping
water vapour.
Tap fi rst on the upper circle and
then on the lower circle to switch
off and restart the system. Use
this function to reset errors or re-
set the password for the settings.
38