clage Zip HydroTap G5 BCS 20 Gebrauchsanleitung Seite 36

LCD Screen Operation - Section B
Note: Hot steam may escape from the fi tting during calibration!
III. CO Settings
2
CO2 SETTINGS
Purge
CO2
PURGE WATER WITH CO2
This process removes water from the sparkling
chamber when a new CO2 bottle is installed.
This is an automatic process that will take 30 seconds.
One 1.2 kg cylinder of CO
sparkling water.
12:12 PM
CO2 CO2
Reset Life
12:12 PM
INFO
is enough for about 180 – 200 litres of
2
Boiling calibration
The boiling point calibration is
started automatically during
initial commissioning and can be
repeated manually here. One run
takes approx. 10 minutes.
Booster
This function should only be
considered when a Booster unit is
installed.
Note: Failing to make the correct
selection for 'Booster' will eff ect
product performance.
Every time the unit is put into
operation and after changing
the CO cylinder, the carbonator
2
must be purged with CO
counter reset.
CO Purge
2
To start the function, tap the
green arrow. The fl ush runs for
approx. 30 seconds and ends
automatically.
CO Reset
2
The consumption counter is reset
by selecting the circle and then
tapping the round arrow.
Life
CO
2
The CO capacity can be set in
2
months or litres. A warning is
shown on the display as soon as
the CO content reaches 20 %.
2
36
and the
2