Quiet Mode - clage Zip HydroTap G5 CS 100 Gebrauchsanleitung

LCD Screen Operation - Section B
IV. Dispense Times
DISPENSE TIMES
V. Light Sensor (Classic- & Classic Plus only)
LIGHT SENSOR
CALIBRATION
This will calibrate the light sensor which will allow the
system to go to sleep when it is dark.
Before we start, the room should be in a typical
ambient lit environment.
Remove any object away from the tap.
Remove any refl ective or shadowing objects from around the fi x-
ture.
VI. Quiet Mode
VII. System Restart
12:12 PM
Chilled
07
SEC
12:12 PM
For all taps with a fi lling function
and for each type of water, a
duration of 5 - 15 seconds can be
set here for automatic dispensing.
Follow the instructions on the
display. Before each calibration,
make sure that the ambient light
corresponds to the typical light-
ing conditions at the installation
site.
A lower fan speed can reduce
noise.
Increasing the speed can improve
the cooling performance.
Levels: 75% / 100% / Auto (de-
fault).
Tap fi rst on the upper circle and
then on the lower circle to switch
off and restart the system. Use
this function to reset errors or re-
set the password for the settings.
29