Kärcher 330 m Betriebsanleitung Seite 17

Starting
- Do not simply discard the packing materials
with the house-hold waste. Take the packing
materials to the appropriate collection areas for
recycling.
- Dirt in the feed water could lead to the appliance
being damaged. To avoid this risk, we recom-
mend fitting a filter with 3/4" connection .
- If you are using an extension cable, it should
always be completely unwound from the cable
drum and have a sufficient cross-sectional area
(10 m = 1,5 mm², 30m = 2,5 mm²).
Operation with high pressure
- The safety ratchet does not lock the lever of the
gun during operation but only prevents it from
opening unintentionally.
Suction operation
- Allow the pump to operate without the high-
pressure hose until water appears at the high-
pressure outlet without any more bubbles.Then
reattach the high-pressure hose.
Operation with Detergent
- We recommend that you use detergent spa-
ringly for the sake of the environment. Observe
the recommended dosage on the detergent la-
bel.
- By offering you an individualised range of clea-
ning and preserving agents, Kärcher guaran-
tees trouble-free operation of the unit. Request
more information or ask for our catalogue and/
or individual information brochures on specific
detergents.
Universal cleaner ................. Profi RM 555 ASF
This cleaning agent may be used undiluted.
Universal cleaner ............. Profi RM 555 ULTRA
Automotive cleaner .......... Profi RM 555 ULTRA
House and garden cleaner Profi RM 565 ULTRA
Boat cleaner ..................... Profi RM 575 ULTRA
Before using, these cleaning agents must be
diluted with 9 parts of water (1:9).
- We recommend the following cleaning methods:
Step 1: Loosening dirt
Spray on detergent sparingly and allow to react
for a short time.
Step 2: Removing dirt
Spray off the loosened dirt with the high-
pressure spray.
18
Switching Off
- In the event of extended work breaks (more than
5 minutes), switch off the pump to avoid dama-
ge due to water overheating.
- Pull the trigger until there is no more pressure in
the appliance, and secure the trigger with the
safety ratchet against unintentional opening.
- Frost will destroy an appliance which has not
been completely emptied of water. Ideally, the
appliance shold be stored in a frost-free room.
Troubleshooting
! Note: Disconnect the appliance from the power
mains before all repair work.
Appliance does not Work
- Check whether the voltage shown on the rating
plate corresponds to that of the power source.
- Check the connector cable for damage.
- If the motor overheats, allow it to cool down for
a few minutes. Then switch back on again.
Appliance does not reach Operational Pressure
- Vent the appliance.
- Clean the strainer in the water connection.
- Check the inlet water flow rate.
- Check all inlet pipes to the pump for leaks or
block-age.
Strong Pressure Fluctuations
- Clean the high-pressure nozzle. Remove dirt
from the nozzle hole with a needle and then
rinse out with water from the front.
Pump Leaks
- 3 drops per minute are permissible. In the case
of more serious leakage, you should contact the
authorized customer service.
Spare Parts
- A selection of the most common spare parts
numbers is listed at the end of these operating
instructions.
General Information
Purpose
- Use the appliance to clean machines, vehicles,
buildings, tools etc.
- Clean facades, terrasses, garden equipment
etc. without detergent only with the high-
pressure spray.
- Engines may only be cleaned at locations with
appropriate oil separators (environmental
protection).
Safety Equipment
The safety valve is also an overflow valve.
When the hand-held spray gun is closed, the
valve opens and water flows back to the suction
side of the pump.
Technical Data
Power connection
Voltage (1~50 Hz) ............................ 230 V
Connected load .............................. 1,75 kW
Mains fuse (slow) ............................... 10 A
Protection class .................................... 1
Water connection
Supply temperature (max.) ................ 40 °C
Supply rate (min.) ............................. 600 l/h
Supply pressure (max.) ...................... 12 bar
Supply hose – length (min.) ........... 7,5 m
– diameter (min.) ......... 1/2 in
Suction height from open tank
at a water temperature of 20°C ........... 1 m
Performance data
Operating pressure (max.) ............... 100 bar
Flow rate ........................................... 400 l/h
Detergent intake ................................. 20 l/h
Recoil force of hand-held spray gun
at operating pressure (max.) .............. 15 N
Sound pressure level (DIN 45635) . 74,5 dB (A)
Dimensions
Length ............................................... 350 mm
Width ................................................. 225 mm
Height ............................................... 260 mm
Weight with accessories .................... 12 kg