UBSAN ZINO MINI PRO Benutzerhandbuch Seite 9

• Aircraft Battery Installation
1) Take a fully charged battery
2) Insert the battery into battery compartment,
while pressing the left and right edges behind of
the battery (As shown in illustration) push in,
until the battery buckles are fully locked. You
should hear buckle locking sound.
3) Battery top should be flush with aircraft back
that confirms battery is in place.
• Intelligent Battery Functions
1) Power display: The battery has a power indicator, which can display the current batter
power levels.
2) Auto-Discharging Function: To prevent swelling, the full battery automatically
discharges to 96% battery level when it is idle for 1day. It takes approximately five to six
days to discharger the battery to 60%. It is normal to feel moderate heat being emitted
from the battery during the discharging process.
3) Balanced Charging: During charging, the voltages of the battery cells are automatically
balanced.
4) Overcurrent Protection: The battery stops charging if an excess current is detected.
5) Overcharge Protection: The battery stops charging automatically once fully charged.
6) Over-discharge Protection: Discharging stops automatically to prevent excess
discharge.
7) Short Circuit Protection: The power supply is automatically cut if a short circuit is
detected.
8) Battery Cell Damage Protection: HUBSAN App displays a warning message when a
damaged battery cell is detected.
9) Hibernation Mode: When the battery is on and is left unused for over 20 minutes, the
battery will turn off the output after 20 minutes and will enter into a non-working state
to maintain the power. If the battery is left in the drone powered on, the battery will
automatically shut down once battery power drops below 5%. If the drone is turned off,
the battery will automatically enter the sleep state to prevent over-discharge. AT this
time, short pressing the battery switch will not display battery power, the battery can
wake up by charging again.
10) Communication: Information about the battery's voltage, capacity, and current is
transmitted to the aircraft.