UBSAN ZINO MINI PRO Benutzerhandbuch Seite 18

Run X_HUBSAN 2.0 APP and select the aircraft model.
•
Short press, the aircraft power button, then press and hold for a few seconds to
•
turn it on.
Short press the transmitter power button, then press and hold for a few seconds
•
to turn it on, connect the transmitter to your mobile device with the RC cable.
Before Pairing
Start binding (This step is only required when first binding or replacing the
•
transmitter, you need to do it manually.)
Long press the aircraft bind button to enter the binding mode.
Press and hold the FN + Photo key combination to enter the binding mode, put
the aircraft close to the remote-control to complete the bind.
TIPS:
The binding process has been completed in the factory. The aircraft can take off directly.
After entering binding mode, all LEDs flash rapidly and become solid after binding is
successful.
Please keep the remote controller at least 1 meter away from drone during binding
mode.
4. Aircraft Calibration
• Horizontal Calibration
During the flight, if the drone shows a significant horizontal deviation, please land, and
disarm the drone. Place the drone on a perfectly leveled horizontal ground. Enter the
APP setting interface, select horizontal calibration. Drone will automatically perform the
calibration, the four heading lights will flash, and it will stay on after the calibration is
completed.
Do not move the aircraft during calibration.
After Pairing