Specifications - Makita KP0800 Betriebsanleitung

ENGLISH
1. Pointer
2. Knob
3. Lock button or Lock-off button
4. Switch trigger
5. Planer blade
6. Rear base
7. Foot
8. Socket wrench
9. Bolt
10. Drum
11. Drum cover
12. Adjusting plate
13. Inside edge of gauge plate
14. Blade edge
15. Screws
16. Heel

SPECIFICATIONS

Planing width
Planing depth
Shiplapping depth
No load speed (min
Overall length
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for planing wood.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
PLANER SAFETY WARNINGS
1. Wait for the cutter to stop before setting the tool
down. An exposed cutter may engage the surface
leading to possible loss of control and serious injury.
2. Use clamps or another practical way to secure and
support the workpiece to a stable platform. Holding
the work by hand or against your body leaves it
unstable and may lead to loss of control.
3. Rags, cloth, cord, string and the like should never
be left around the work area.
4. Avoid cutting nails. Inspect for and remove all
nails from the workpiece before operation.
5. Use only sharp blades. Handle the blades very
carefully.
6
Explanation of general view
17. Back side of gauge base
18. Gauge plate
19. Gauge base
20. Pan head screw
21. Planer blade locating lugs
22. Heel of adjusting plate
23. Set plate
24. Inside flank of Gauge base
25. Mini planer blade
26. Groove
27. Hex. flange head bolt
28. Dust bag
29. Nozzle
30. Fastener
31. Elbow
32. Start
Model
-1
)
Net weight
Safety class
6. Be sure the blade installation bolts are securely
ENE001-1
tightened before operation.
7. Hold the tool firmly with both hands.
ENF002-1
8. Keep hands away from rotating parts.
9. Before using the tool on an actual workpiece, let it
run for a while. Watch for vibration or wobbling
that could indicate poor installation or a poorly
balanced blade.
10. Make sure the blade is not contacting the
workpiece before the switch is turned on.
11. Wait until the blade attains full speed before
cutting.
GEB010-3
12. Always switch off and wait for the blades to come
to a complete stop before any adjusting.
13. Never stick your finger into the chip chute. Chute
may jam when cutting damp wood. Clean out
chips with a stick.
14. Do not leave the tool running. Operate the tool
only when hand-held.
15. Always change both blades or covers on the
drum, otherwise the resulting imbalance will
cause vibration and shorten tool life.
16. Use only Makita blades specified in this manual.
17. Always use the correct dust mask/respirator for
the material and application you are working with.
33. End
34. Cutting line
35. Screw
36. Edge fence (Accessory)
37. Sharpening holder
38. Wing nut
39. Blade (A)
40. Blade (B)
41. Side (D)
42. Side (C)
43. Limit mark
44. Chip cover
45. Screwdriver
46. Brush holder cap
KP0800
82 mm
2.5 mm
9 mm
17,000
285 mm
2.6 kg
/II