UBSAN Zino MINI SE Bedienungsanleitung Seite 42

TF Card
(1) support TF card, U3 above 16G/32G/64G/128G.
(2) hot plug is supported. You can insert the TF card even if drone is powered on. But it is
recommended to plug in the TF card when drone is powered off.
FAQ
1.The mobile device and remote control cannot be connected
(1) Check whether the status of the APP control signal icon has changed
(2) For USB Settings on android phones, check out "Android phone connection
tutorial"
2. FPV transmission freezing, gets stuck or easy to disconnect
(1) Adjust the antenna Angle and point vertical side of the antennas to the
aircraft, without anything blocking between antennas
(2) Change the flight site, please do not fly near tall buildings, or near signal tower
(3) Update the latest firmware
3.Abnormal aircraft hovering
(1) Change the flight site, please do not fly near tall buildings and signal towers
(2) Do the compass calibration and horizontal calibration
(3) Wind is too strong to affect the flight
4. Aircraft GPS accuracy is not precise or cannot pass the GPS accuracy test
(1) in the open area of the outdoor with GPS over 6 satellite
(2) Walk around near the aircraft
(3) Replace the mobile device
5.The battery cannot charge
Re-plug the charger and battery
6. short flight times
Battery overcharge or high temperature environment can easily lead to reduction of
battery life, it is recommended to keep the remaining 60% or so, full charge again before
use
42