UBSAN Zino MINI SE Bedienungsanleitung Seite 31

2. Aircraft will land automatically at the same point upon low battery RTH activation, if
there is no GPS signal or weak GPS signals
3.When taking off, if it is forced take off with weak GPS signals or GPS signals are not
good, the aircraft will automatically return to the place where it achieved, good GPS
signal for the first time.
4. If the power is less than 1% or the battery voltage is less than 5.6V, aircraft will enter
in forced landing mode.
When the aircraft loses connection with the remote control for more than 5 seconds,
the aircraft automatically returns or land directly. Performance requirements:
(1) After the aircraft loses control for 5 seconds, it triggers automatic return.
(2) If the drone reconnects, it will continue to perform the returning procedure when
Failsafe RTH mode is activated.
(3) Landing directly when there is no GPS signal, or the signal is not strong.
Landing Apron Search
When the aircraft is landing or returned to a height of about 10 meters from the ground,
it will automatically enter the search for the drone apron function.
1. The gimbal camera points downward to optically search for the Aircraft parking
apron[H], Apron requirements: 1 Sharp contrast, 2 white "H" lettering, 3 Apron without
obstruction.
2. Once drone locks the apron visually it will descend smoothly on apron. When landing
to a height of less than 3 meters, the aircraft camera will switch to forward view and no
longer adjust the position of the aircraft. From this altitude aircraft will land quick. If an
error is identified or other unexpected circumstances occur, press the stop button to
exit the function.
Failsafe RTH
31