Transmitter Calibration - UBSAN Zino MINI SE Bedienungsanleitung

3. Closer Sate, the two antennas are properly separated to maintain a wide receiving
range.
4.Do Not Form an occlusion or cross between the antennas.

Transmitter Calibration

Start Calibration: Push and hold both sticks to the upper left corner as shown in picture
below, and power on the transmitter, the transmitter will enter calibration state and
start Beeping; release the power button and sticks.
Calibrate Sticks: Rotate both sticks in circles to their maximum travel for at least three
times, and release the sticks
Exit and save calibration: long-press any button except the power button until the
remote controller stops beeping and the screen lights on
21