Suitable Amplifiers - auna Octavox Bedienungsanleitung

EN
20

SUITABLE AMPLIFIERS

All speakers are typical 4 ohm speakers that harmonise with any HiFi
amplifier without damaging it. We recommend an amplifier with an output
power according to the table below; in case of doubt, the value may also be
slightly exceeded. Please note: When listening at high volumes, it is more
likely to damage a speaker with an amplifier that is too low in power than
with a device that "has too much power". Octavox speakers can actually
play music louder than many other HiFi speakers. If you still hear distortion,
reduce the volume slightly.
Model
Octavox 701
Octavox 702
Octavox 703
Connection 701 MKII
We recommend that you use speaker cable with a diameter of at least 2.5
mm² for the Octavox 701. The shorter the cable, the better the sound. Cables
up to about 5 m in length are absolutely safe to use. For a conventional
connection without bi-wiring, please connect the upper and lower
connection pairs with the supplied bridges as shown in the illustration.
Then connect one end of your speaker cable to the two lower terminals of
your speaker. Now, when connecting the other end to the amplifier, be sure
to connect the PLUS terminal (usually RED) of the amplifier to the PLUS
terminal of the Octavox connection panel - and MINUS (usually BLACK) to
the MINUS.
Amplifier output power
200 W
100 W
150 W