Using The Product - Beko B5RCNE594ZXB Bedienungsanleitung

Using the product

3. Energy Saving (Display Off) Indicator
Energy saving function is enabled automatically
and the energy saving symbol (
when the door of the product is not opened or
closed for some period of time. When the energy
saving function is active, all symbols on the screen
other than the energy saving symbol shall be
turned off. When the energy-saving function is
active, pressing any key or opening the door will
deactivate the energy-saving function and the
display signals will return to normal. The energy-
saving function is a function activated ex-factory
and cannot be cancelled.
4. Fault Condition Indicator
This indicator ( ) shall be active when your
refrigerator cannot perform adequate cooling
or in case of any sensor error. On the freezer
compartment temperature indicator the letter
"E" and on the cooler compartment temperature
indicator the numbers 1, 2, 3 will be displayed.
The numbers on the indicator specifies the service
regarding the failure. If you place hot food in the
freezer compartment or leave its door open for a
prolonged time, an exclamation mark can be lit.
This is not a fault, this warning shall be removed
when the food is cooled down or when any key is
pressed.
5. Quick Freezing Key
When the quick freeze key is pressed, the LED
on the key is illuminated and the quick freeze
function shall be activated. Freezing compartment
temperature is set to -27 Celcius. Press the
key again to cancel function. The quick freezing
function shall be automatically cancelled after 24
hours. To freeze a large amount of fresh food,
press the quick freeze key before placing the food
in the freezer compartment.
*Handle Light Function Setting Key
Handle light function might be switched between open
and closed modes by pressing quick freezing button
( ) for 3 seconds. In the closed mode, the handle
light is only activated when the appliance door is
Refrigerator / User Guide
opened and it goes out after a while after the door is
closed. In the open mode, the handle light is activated
) is displayed
when the appliance door is opened, the handle light
stays on dimly after a while after the door is closed.
The handle light function is set to the ex-factory closed
mode.
6. Wireless Key
This button (
to your appliance through HomeWhiz mobile
application. If the button is pressed for a long
time (3 secs) the LED on the button will blink
(in 0.5 second intervals). The link between the
appliance and the home network is initialized.
After the wireless connection with the appliance
is established the LED will be lit solid. After initial
setup, the connection can be activated/deactivated
by pressing this button. The LED on the button
shall flash quickly (at 0.2 second intervals) until the
connection is established. When the connection is
active, the LED shall light up continuously.
If the connection cannot be established for a long
period, check your connection settings and refer
to the "Troubleshooting" section provided in the
user manual. HomeWhiz application shall be used
for wireless connection. The steps for setup are
explained through the application during setup.
You can access the application by scanning the
QR code on the HomeWhiz label on the appliance.
The application can be obtained from App Store
or from Play Store for Android devices. For details
visit https://www.homewhiz.com/.
7. Support Service Key
Press this button for 3 seconds to activate the
support key. Detailed information regarding the
use of support service may be found on "Support
Service Feature" section.
8. Cooling Compartment OFF (Vacation)
Function Key
To activate vacation function (
button for 3 seconds. The vacation mode will
be activated and the LED on the button will
be lit. "- -" shall be displayed on the Cooling
Compartment temperature indicator and the
15 / 27 EN
) is utilized to connect wirelessly
), press the