Front Panel Functions - Marshall 1962 Kurzanleitung

ENGLISH

FRONT PANEL FUNCTIONS

1 2 3
1. POWER SWITCH
Turns the amp on and off.
2. STANDBY SWITCH
The standby switch is used in conjunction with the
power switch to 'warm up' the amp before use.
Always turn the power on for two minutes before
switching the standby switch to the 'on' position.
The standby switch should be set to the 'off'
position during breaks in performances instead
of leaving the amp on full power.
3. INDICATOR
The power indicator will light when the amp's
mains power is switched on.
4. SPEED
Controls the speed at which the 'tremelo' effect
oscillates.
5. INTENSITY
Controls the depth of the 'tremelo' effect's
oscillation.
Note: 'tremelo' will only work when playing
through channel 2.
6. PRESENCE
Adjusts the high frequencies of the power amp.
Increasing the high frequencies adds more bite
to your sound.
7. BASS
Adjusts the low frequencies of the amp. It will
add bottom end and depth to your sound.
4
6
4 5 7 8 9
8. MIDDLE
Adjusts the mid frequencies of the amp, giving
you anything from scooped mids to a fat and
full sound.
9. TREBLE
Adjusts the upper frequencies of the pre-amp.
Your tone will get brighter as it is turned up.
10. VOLUME I
Controls the overall output level of channel 1.
This channel is for a higher treble response than
channel 2.
11. VOLUME II
Controls the overall output level of channel 2.
Channel 2 is voiced for normal response and
has a more rounded tone than channel 1.
12. INPUTS
1 (Top): Connects the guitar to channel 1.
1 (Bottom): Connects the guitar to the lower
sensitivity input on channel 1.
2 (Top): Connects the guitar to channel 2.
2 (Bottom): Connects the guitar to the lower
sensitivity input on channel 2.
Note: some guitar players prefer to mix the
two channels together by connecting a short,
screened patch lead between the bottom input
of channel 1 and the top input of channel 2.
If you then plug your guitar into the top input
of channel 1, you can mix the different tonal
characteristics of each channel.
10 11 12