Hilti Nuron GFB 6X-22 Original Bedienungsanleitung Seite 25

3 Description
3.1 Product overview
3.2 Intended use
The product described is a hand-held, cordless band file. It is designed for grinding and polishing metal
surfaces in awkward places, without use of water.
• For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
3.3 Possible misuse
Do not use the product for wet grinding.
Do not use the product to work on hazardous or flammable materials (e.g. asbestos, magnesium, wood).
3.4 Items supplied
Band file, side handle, file arm, Torx wrench, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
3.5 Temperature-dependent motor protection
The temperature-dependent motor protection system monitors current input and motor temperature and
thus prevents the power tool overheating.
If the motor is overloaded through application of excessive working pressure, the product's performance
drops noticeably or it might stall completely.
If the product stalls or slows significantly due to overloading, relieve the pressure applied to the product and
then allow it to run under no load for approx. 30 seconds.
3.6 Status indicators of the Li­ion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and the battery's state of health.
*2327539*
1
2327539
Eccentric screw
@
Locking screw for swivel arm
;
Lockable on/off switch
=
Adjusting knob for speed
%
Battery status indicator
&
Battery release button
(
Battery
)
Dust filter
+
Side handle
§
Casing cover
/
Drive roller
:
Securing screws for file arm
∙
File arm
$
Adjusting screw for file arm
£
Abrasive belt
|
Contact roller
¡
Spindle lock button
Q
English 19