Remote Control - HOMCOM 824-034V90 Montageanleitung

Remote control and panel display：

REMOTE CONTROL

The remote control uses on button cell battery, type CR2025(3V).To remove the battery carriage use your thumb to
squeeze the release tab to the right and then pull the carriage out. Place the battery into the carriage and slide the
carriage back into the remote. We recommend the use of a Lithium-ion battery for longer use. NOTE: Follow
battery disposal instruction on battery packaging, or contact your local safety council for safely disposal of
batteries.
Before using the remote control, you must remove the insulating film as shown in picture below.
All functions performed with remote control work identically to the unit control panel.
CAUTION
1. Use as per the rating voltage.
2. Do not repair or remake the appliance by yourself, It should be repaired by the repairmen.
3. Do not operate the appliance with wet hands, in order to avoid damage.
4. If the supply cord is damaged, it must be replace by a special cord or assembly available
from the manufacturer or its service agents.
5. When the appliance is not in use, switch it off and unplug it.
6. Do not insert things to air outlets and inlets, in order to avoid damage.
7. Do not use the appliance near explosive and combustible gas.
8. Use the appliance only on a flat surface.
9. Do not use outdoors.
10. The level of water tank should be not over "MAX" scale at any time, when humidifying, the
total level of water tank should be "MIN" scale.
3