Working Advice; Maintenance And Service; Maintenance And Cleaning - Bosch GKS 36 V-LI Professional Originalbetriebsanleitung

OBJ_BUCH-304-004.book Page 28 Wednesday, February 20, 2008 10:08 AM
28 | English
Protection Against Deep Discharging
The Li-ion battery is protected against deep dis-
charging by the "Electronic Cell Protection
(ECP)". When the battery is empty, the machine
is switched off by means of a protective circuit:
The inserted tool no longer rotates.

Working Advice

Protect saw blades against impact and shock.
Guide the machine evenly and with light feed in
the cutting direction. Excessive feed significant-
ly reduces the service life of the saw blade and
can cause damage to the power tool.
Sawing performance and cutting quality depend
essentially on the condition and the tooth form
of the saw blade. Therefore, use only sharp saw
blades that are suited for the material to be
worked.
Sawing Wood
The correct selection of the saw blade depends
on the type and quality of the wood and whether
lengthway or crossway cuts are required.
When cutting spruce lengthways, long spiral
chips are formed.
Beech and oak dusts are especially detrimental
to health. Therefore, work only with dust extrac-
tion.
Sawing with Parallel Guide (see figure D)
The parallel guide 11 enables exact cuts along a
workpiece edge and cutting strips of the same
dimension.
Sawing with Auxiliary Guide (see figure E)
For sawing large workpieces or straight edges, a
board or strip can clamped to the workpiece as
an auxiliary guide; the base plate of the circular
saw can be guided alongside the auxiliary guide.
Utility Hook (see figure F)
Your tool is equipped with a utility hook 1 for
hanging it, e. g., to a ladder, etc. Simply fold out
the utility hook 1 to the required position.
When the power tool is hung, pay attention
that the saw blade is protected against ac-
cidental touching. Danger of injury.
1 609 929 P97 | (20.2.08)
Fold the utility hook 1 back in again when you
are ready to continue working.
Recommendations for Optimal Handling of the
Battery
Protect the battery against moisture and water.
Store the battery only within a temperature
range between 0 °C and 45 °C. As an example,
do not leave the battery in the car in summer.
Occasionally clean the venting slots of the bat-
tery using a soft, clean and dry brush.
A significantly reduced working period after
charging indicates that the battery is used and
must be replaced.
Observe the notes for disposal.

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine itself (e. g.
maintenance, tool change, etc.) as well as
during transport and storage, remove the
battery from the power tool. There is danger
of injury when unintentionally actuating the
On/Off switch.
For safe and proper working, always keep
the machine and ventilation slots clean.
The retracting blade guard must always be able
to move freely and retract automatically. There-
fore, always keep the area around the retracting
blade guard clean. Remove dust and chips by
blowing out with compressed air or with a
brush.
Saw blades that are not coated can be protect-
ed against corrosion with a thin coat of acid-free
oil. Before use, the oil must be removed again,
otherwise the wood will become soiled.
Resin and glue residue on the saw blade produc-
es poor cuts. Therefore, clean the saw blade im-
mediately after use.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
Bosch Power Tools