LaserLiner ThermoCamera HighSense Bedienungsanleitung Seite 48

16.0
CustomApps: Menu
One-click configuration allows the device to be configured quickly using the CustomApp
MENU
function for a wide range of standard applications, even with extensive parameter setups.
OK
CustomApps can be accessed by pressing the menu hot key for 2 seconds or from the Settings
menu. Further information on CustomApps is available here:
2 sec
https://packd.li/ll/ca2/ap/wi
16.1
CustomApps: Factory Settings
All parameters are reset to the default factory settings, the language settings remain the same. Due to the
number of parameters and the subsequent possibility of entering incorrect information, it is advisable to
reset the the camera to the default settings before every important measurement. This allows parameters
to be entered from a known starting point.
16.2
CustomApps: ColdView-Inspection
16.3
CustomApps: HotView-Inspection
48
EN
ColdView-Inspection is suitable for detailed exami-
nation of cold areas. Problem points such as thermal
bridges, cold air flows or air leakages, such as around
window frames or doors, can be identified quickly
and accurately. The MIX image overlays the digital
image on the coldest 20 % of the temperature range
captured on site. The condensed colour palette pro-
vides an optimum visualisation of the precise extreme
temperature points. A standard colour palette can be
used for subsequent temperature measurement of the
extremes in order to produce a balanced colour image
for measurement and evaluation. The centre point (P1)
provides direct temperature measurement.
HotView-Inspection is suitable for detailed examina-
tion of hot areas and determination of points with pre-
dominantly high temperatures. These include heating
pipes, fuses and electrical connections. The MIX image
overlays the digital image on the warmest 20 % of the
temperature range captured on site. The condensed
colour palette provides an optimum visualisation of
the precise extreme temperature points. A standard
colour palette can be used for subsequent temperature
measurement of the extremes in order to produce a
balanced colour image for measurement and evaluati-
on. The centre point (P1) provides direct temperature
measurement.