Alecto WS5200 Gebrauchsanleitung Seite 64

Command Mode
[MODE] Pressure Units
of Measure
[MODE] Relative
Pressure
Calibration
[MODE] Temperature
Units of
Measure
[MODE] Wind Units of
Measure
[MODE] Rain Units of
Measure
[MODE] Exit Set Mode
[MODE] + 2 seconds means to press and hold the MODE button for two
seconds.
[MODE] means to press the MODE button.
Table 8: Set mode sequence and commands summarization
5.4 Barometric Pressure Display
5.4.1 Viewing Absolute vs. Relative Pressure
Press and hold [RAIN/PRE] for two seconds switch between Rain and
Pressure. While in Pressure mode Press [RAIN/PRE] to switch between
absolute and relative pressure
Settings
Press [TEMP +] or
[WIND -] to change units
of measure between hap,
mmHg or inHg.
Press [TEMP +] or
[WIND -] to adjust
relative pressure up or
down
Reference Section
5.4.3for details on
calibration of relative
pressure.
Press [TEMP +] or
[WIND -] to change
temperature units of
measure between °F
and °C.
Press [TEMP +] or
[WIND -] to change wind
units of measure between
km/h, mph, knots, m/s and
bft.
Press [TEMP +] or
[WIND -] to change rain
units of measure between
in and mm.
64
Image