Making Ice; Twist Ice - Matic - Beko RDNT231I20XB Bedienungsanleitung

WARNING!
•
according to the family's daily or meal
based consumption needs.
•
airtight manner to prevent them from
drying even if they are going to be kept
for a short time.
• Materials necessary for packaging:
• Cold resistant adhesive tape
• Self adhesive label
• Rubber rings
• Pen
Materials to be used for packaging
resistant to cold, humidity, odor,
oils and acids.
allowed to come in contact with the
previously frozen items to prevent their
partial thawing.
Frozen food must be used immediately
after they are thawed and they should
never be re-frozen.

Making ice

(This feature is optional)
Fill the ice container with water and place
it into the freezer compartment.
Your ice will be ready approximately
in two hours.
You can remove the ice in the ice container
by removing it from the freezer
and twisting it.
Twist Ice – matic
(This feature is optional)
• Remove the water tank by rotating it to
the left.
• Open the water tank cover by turning it
and add water to the water tank up to the
lower part of the water tank cover.
• Place the water tank on its place as
have it seated by rotating it on the
direction of the arrow. Water shall be
poured down to the icebank.
• When ice has formed, rotate icebank
knob in the direction of the arrow to allow
that the ice is dropped down to
the ice drawer.
• Take the ice cubes by pulling
ice drawer out.
• Pull the front face towards you in order to
wash the icebank, and put it on the slides
on the interior area and push it to its place
in order to replace it.
• Pull the twist icematic unit towards you
in order to remove the unit, and put it on
the slides on the ceiling and push it to its
place in order to replace it.
12 EN