LAUNCH TOUCH PRO ELITE Schnellstartanleitung Seite 2

3
Job Menu
It mainly includes the following function modules:
To configure the tool to operate as a professional
Diagnose
diagnostic tool.
A quick access to the I/M Readiness function of
I/M
OBD II Diagnosis.
This option presents a quick way to check for DTCs,
isolate the cause of the illuminated Malfunction
Indicator Lamp (MIL), check monitor status prior to
OBD II
emissions certification testing, verify repairs, and
perform a number of other services that are
emission-related.
Measures the current voltage of the vehicle's
Battery
battery.
Voltage
To perform common repair & maintenance items,
which includes Oil Lamp Reset, Steering Angle
Sensor (SAS) Reset, Electronic Parking Brake
Reset
(EPB), Battery Maintenance System (BMS) Reset,
Diesel Particulate Filter (DPF), Electronic Throttle
Position Reset, ABS bleeding.
To update vehicle diagnostic software and APK.
Update *Note: This function requires a stable network
connection.
Includes Diagnostic report, Diagnostic record,
Data
Feedback and DTC library etc.
To make some system settings, including Network
Settings
setup, Email and Brightness etc.
4
Preparation
1. Turn the ignition off.
2. Locate vehicle's DLC: It
provides standard 16 pins
and is generally located on
driver's side, about 12
inches away from the
center of dashboard. See
Figure DLC Location. If
DLC is not equipped under
dashboard, a label
indicating its position will
be given.
In case no DLC is found, please refer to Automobile Repair Manual.
3. Plug one end of the diagnostic cable into the DB-15 connector of
the tool, and tighten the captive screws. Connect the other end to
the vehicle's DLC.
Diagnostic Cable
Display Tablet
*Note: The tool ONLY works with the 12V passenger cars equipped with
standard OBD-II diagnostic socket.
4. Turn the ignition key on.
DLC
Vehicle