Campingaz CAMP'BISTRO 3 Bedienungsanleitung Seite 8

NOTE: Unless otherwise specified, following generic
terms "appliance / unit / product / equipment / device"
appeared in this instruction manual all refer to the
products "CAMP'BISTRO 3" / "CAMP'BISTRO ELITE" /
"CAMP'BISTRO PLUS".
Consumption: 160 g/h (2.2 kW)
Category: butane direct pressure
Thank you for choosing this stove Campingaz
CAMP'BISTRO 3 / CAMP'BISTRO ELITE / CAMP'BISTRO
PLUS.
A - IMPORTANT: YOU ARE USING GAS, BE
VERY CAREFUL!
The purpose of these instructions is to enable you
to use your stove Campingaz
/ CAMP'BISTRO ELITE / CAMP'BISTRO PLUS
correctly and safely.
Please read them carefully to familiarise yourself
with the stove prior to assembling the cartridge.
Keep these instructions in a safe place so that you
can refer to them when needed.
Please observe these instructions as well as
the safety measures printed on the Campingaz
CP250/ CP250 SP cartridges. Failure to observe
these instructions may result in the user and
people in the immediate vicinity being put at risk.
The stove must be used exclusively with
Campingaz CP250/ CP250 SP cartridges. Using
®
other gas containers may be dangerous.
The Société Application Des Gaz accepts no responsibility
when cartridges of any other brand are used.
The stove should only be used outside premises
and kept away from inflammable materials.
GB
It is imperative NOT to use the stove in caravans,
cars, tents, huts, sheds or any small enclosed
areas.
The stove consumes fuel through combustion
or consumption of oxygen and gives off certain
substances and gas, which could be dangerous
such as carbon monoxide.
Carbon monoxide is an odorless, clear gas that
can cause flu-like symptoms, sickness, illness,
and possibly death if produced inside aforesaid
enclosed areas through use of the stove without
proper ventilation.
The stove should not be used while sleeping or left
unattended.
Do not use a stove which leaks, functions incorrectly
or is damaged. Return it to your retailer who will
inform you of your nearest after-sales service center.
Never modify the stove or use it for purposes for
which it is not intended.
If the cartridge is automatically ejected from the
regulator, DO NOT CONNECT THE CARTRIDGE AGAIN,
let the stove cool down completely before any use.
Except specific Campingaz
for this stove, do not use : containers smaller than
12cm or larger than 26cm in diameter; vessels with
concave or convex bottoms; griddles, planchas or
stones (Fig. 12).
The pan support has higher edges (8) on the
cartridge side. Those edges block cooking utensils
getting above of the cartridge compartment. Never
position a cooking utensil above those higher pan
support edges.
Always remove the gas cartridge from the stove
during storage or transportation.
This product is designed for a normal private use,
not intended for commercial purposes.
Figures: see pages 2 to 4
CAMP'BISTRO 3
®
®
accessories developed
®
B - PREPARATION FOR OPERATION
- Remove the stove from its packaging.
Installing a CAMPINGAZ
(When the existing cartridge is empty, read section D:
"Changing the cartridge")
To install or remove a cartridge, always work in a well-
®
ventilated area, preferably outside and never in the
presence of a flame, heat source or spark (lit cigarette,
electrical equipment, etc.) at a good distance from
other people and flammable material.
AS CAMPINGAZ
HAVE VALVES, EVEN IF THEY ARE NOT EMPTY,
THEY MAY BE REMOVED FROM THIS STOVE TO
MAKE IT EASIER TO TRANSPORT, AND THEY MAY
BE FITTED TO OTHER EQUIPMENT FROM THE
CAMPINGAZ
®
ARE DESIGNED TO OPERATE EXCLUSIVELY WITH
THESE CARTRIDGES.
- Open the cartridge cover (3) (Fig. 2).
- Check that the ignition button (1) is set to position "l"
by turning it clockwise and that the lever (2) is set to
UNLOCK (Fig. 3).
Comment: the gas cartridge can only be locked if the
ignition button is in position "l".
- Check that the seals between the stove and the gas
container are in place and in good condition before
connecting the gas container (see Fig. 4). Do not use
this stove if the seal is missing or damaged. Return
it to your dealer.
- Install the cartridge in its housing, slot "F" facing
upwards, and engage the cartridge guide "G" firmly
into the slot (Fig. 5).
- Lock the cartridge by moving the lever (2) to the LOCK
position (Fig. 6). Close the cartridge compartment
cover (3).
The stove is ready for use.
CAUTION: Make sure the cartridge slot "F" is pointing
upward and inserted in the cartridge guide "G".
Incorrect positioning of the gas cartridge (9) will cause
the regulator to break and/or gas leakage, producing a
hissing sound and gas smell.
In case of leakage (gas smell before opening the valve),
put immediately the stove outside, in a well-ventilated area,
without inflammation source, where it will be possible to
locate and stop the leak. If you wish to check the tightness
of the stove, do it outside. Do not try to locate a leak with
a flame, use gas leak detection liquid.
8
cartridge CP250/ CP250 SP
®
CP250/ CP250 SP CARTRIDGES
®
CP250/ CP250 SP RANGE WHICH