Electrical Installation - SICK GLD20 Betriebsanleitung

5

Electrical installation

8026844/2022-06-09 | SICK
Subject to change without notice
< 0.55 Nm
< 0.3 Nm
(Force < 30 N)
< 0.8 Nm
< 0.8 Nm
Figure 1: Tightening torque
The sensors must be connected in a voltage-free state. The following information must
be observed, depending on the connection type:
– Male connector connection: Pin assignment
– Cable: Wire color
– Terminal connection: Pin assignment
Terminal connection:
1. Open the cover.
2. Swivel the 3/8" MPT (Male Pipe Thread) fitting in the right position horizontally or
vertically.
3. Loosen 3/8" MPT connection.
4. Remove sealing plugs.
5. Lead voltage-free supply cable through.
6. Connect sensor as per
7. Retighten 3/8" MPT fitting with seal so that the IP enclosure rating of the device is
ensured.
< 0.4 Nm
table 15.
O P E R A T I N G I N S T R U C T I O N S | GLD20
OPERATING INSTRUCTIONS
en
25