General; Compatible Products - Nibe RMU S40 Installateurhandbuch

General

With RMU S40 you can control and monitor your NIBE heat
pump/indoor module/control module (main product) from
another room in the house.

COMPATIBLE PRODUCTS

Main products in NIBE S-series.*
*RMU S40 is not compatible with SMO S30.
CONTENTS
K IT C H EN K IT C H EN
2 2 . 3 ° 2 2 . 3 ° 2 2 . 3 °
r r r
Ou td oo Ou td oo Ou td oo
-5 .6 ° -5 .6 °
ar y
05 Ja nu
12 :4 5
1 x RMU S40 with rear panel
18
MOUNTING
RMU S40 can be installed directly against a wall or with the
aid of the enclosed rear panel. If you use the enclosed rear
panel, you can install RMU S40 in a standard connection
box.
If you want to use the room sensor in RMU S40, the position
of the unit is important, see section
Use all mounting points and mount the module upright, flat
against the wall.Leave at least 100 mm of free space around
the module to allow access and make cable routing easier
during installation and servicing.
Caution
The screw type must be adapted to the surface
on which installation is taking place.
INSTALLATION WITHOUT REAR PANEL
1. Unscrew 2 screws at a distance of 32 mm.
2. Connect RMU S40 to the main product, see section
"Electrical connection".
3. Hang RMU S40 on the screws.
Room sensor.
NIBE RMU S40 | GB