3TECH Ti-940L Bedienungsanleitung Seite 20

CAUTION
– In cleaning procedure the cleanser should be neutralization agent, never use the cleanser or disinfectant containing chlorine.
– Do not immerse the head of the medical device or the medical device to a disinfectant bath, and it is not permitted to clean the medical device in
the ultrasonic unit.
– Autoclaving can be operated in a steam sterilizer that corresponds with EN13060 B/ISO17665-1 Class B or S and is specifi ed for the dental turbines.
– Autoclaving maximum temperature does not exceed 138°(280°F)
– Remove the medical device from the steam sterilizer and store in a dry, dark and cool space protected from dust with minimum exposure to germs.
– Do not immerse the medical device in cold water to speed up the cooling process after removing from the steam sterilizer.
10. Storage
– Reprocessed medical device should be stored in a dry, dark and cool space protected from dust with minimum exposure to germs, corrosive gas
and far away from the heat source.
– Comply with the expiry date of the sterilized items.
80% 106 kPa
+55°C
10%
-40°C
min. 50 kPa
38
11. Troubleshooting
Failure
Excessive noise Worn bearings
Broken bearings Insu cient drive air
Lower rotating speed
pressure
Broken bearings Insu cient drive air
Insu cient cutting power
pressure
Non-rotation of rotor Broken bearings
Blocked water passage or Insu cient water
No spraying Insu cient spraying
and air pressure
Less retention of bur Non-standard bur Dirt in chucking system
Vibration of bur rotation Non-standard bur Broken bearings
No lighting of fi ber optic Broken LED bulb
Root cause Troubleshooting
Replace new bearings
Replace new bearings Re-set air pressure
Replace new bearings Check and set air pressure
Replace new bearings
Clean water channel with the nozzle needle Check
and set water and air pressure
Use the standard bur
Clean and lubricate chucking system
Use the standard bur Replace new bearings
Replace news LED bulb
39