Safety Notes; Installation Instructions; Technical Data; Symbol Description - HANSGROHE Talis M51 200 2jet 73851 Serie Gebrauchsanleitung, Montageanleitung

Safety Notes

Gloves should be worn during installation to prevent
crushing and cutting injuries.
The hot and cold supplies must be of equal
pressures.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• 73876000: The mixer can not used together with a
continuous flow water heater.

Technical Data

Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
The product is exclusively designed for drinking water!

Symbol description

Do not use silicone containing acetic acid!
Adjustment (see page 41)
To adjust the hot water limiter. Using a hot water limiter
in combination with a continuous flow water heater is
not recommended.
Fault
Mixer stiff
Mixer dripping
Water escaping at the threaded
base
Hot water temperature too low
4
English
The check valves must be checked regularly according
to DIN EN 1717 in accordance with national or
regional regulations (at least once a year).
Special accessories (order as an extra)
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
max. 70°C
Hansgrohe recommends not to use as drinking water
65°C
the first half liter of water drawn in the morning or after
max. 70°C / 4 min
a prolonged period of non-use.
Cause
- Cartridge defective, calcified
- Cartridge defective
- connection hoses not completely
screwed into basic body
- O-ring at the connection hose
defective.
- Hot water limiter incorrectly set
Assembly (see page 33)
Maintenance (see page 43)
Dimensions (see page 42)
Flow diagram (see page 43)
Spare parts (see page 47)
XXX = Colors
000 = Chrome Plated
800 = Stainless Steel Optic
extension #43333000 (see page 47)
Adapter (G⅜ / G½ )
#93395000 (see page 48)
Cleaning (see page 46)
Operation (see page 32)
Test certificate (see page 32)
Remedy
- Exchange cartridge
- Exchange cartridge
- Tighten connection hoses by hand
- Exchange O-ring
- Set hot water limiter