Indesit KN3G65SA/CZ S Bedienungsanleitung Seite 11

Choose the screw and the screw anchor according
to the type of material of the wall behind the applian-
ce. If the head of the screw has a diameter smaller
than 9mm, a washer should be used. Concrete wall
requires the screw of at least 8mm of diameter, and
60mm of length.
Ensure that the chain is fixed to the rear wall of the
cooker and to the wall, as shown in figure, so that
after installation it is tensioned and parallel to the
ground level.
S S
A R
KN3G61SA/CZ S
KN3G65SA/CZ S
Table of burner and nozzle specifications
* At 15°C and 1013 mbar- dry gas
** Propane P.C.S. = 50,37 MJ/Kg
*** Butane P.C.S. = 49,47 MJ/Kg
Natural P.C.S. = 37,78 MJ/m
Table 1
Burner Diameter
(mm)
Fast
100
(Large)(R)
Semi Fast
75
(Medium)(S)
Auxiliary
51
(Small)(A)
Nominal (mbar)
Supply
Minimum (mbar)
Pressures
Maximum (mbar)
3
Thermal Power By-Pass
kW (p.c.s.*) 1/100
Nominal Reduced (mm)
3.00 0.7 41
1.90 0.4 30
1.00 0.4 30
TABLE OF CHARACTERISTSICS
Dimensions width 41,7 cm
height 34,0 cm
KN3G61SA/CZ S
depth 39,1 cm
width 41,7cm
height 34,0 cm
KN3G65SA/CZ S
depth 41,0 cm
Volume
56 l
59 l
Maximum absorber
See data plate
power:
width 42 cm
Dimensions of the
height 23 cm
lower compartment
depth 44 cm
may be adapted for use with any type
of gas shown on the data plate, which
Burners
is located inside the flap or, after the
oven compartment has been opened,
on the left-hand wall inside the oven.
Regulation (EU) No 65/2014 supplemen- Regulation (EU) No 65/2014 supplemen-
ting Directive 2010/30/EU. ting Directive 2010/30/EU.
Regulation (EU) No 66/2014 implementing Regulation (EU) No 66/2014 implementing
Directive 2009/125/EC. Directive 2009/125/EC.
Standard EN 60350-1 Standard EN 60350-1
Standard EN 50564. Standard EN 50564.
Standard EN 30-2-1
Energy consumption for Natural
ENERGY LABEL
convection – heating mode:
Convection;
Declared energy consumption for
Forced convection Class – heating
mode:
This appliance conforms to the
following European Economic
Community directives: 2006/95/EC
dated 12/12/06 (Low Voltage) and
subsequent amendments -
2004/108/EC dated 15/12/04
(Electromagnetic Compatibility) and
subsequent amendments - 93/68/EEC
dated 22/07/93 and subsequent
amendments.
2002/96/EC
2009/142 of 30/11/09 (Gas)
1275/2008 (Stand-by/ Off mode)
Data plate, is located inside the flap or, after the oven
compartment has been opened, on the left-hand wall
inside the oven.
Liquid Gas
Nozzle Flow*
1/100 g/h
(mm) *** **
87 218 214
70 138 136
52 73 71
30 30
20 20
35 35
KN3G61SA/CZ S
KN3G65SA/CZ S
Baking
Natural Gas
Nozzle Flow*
1/100 l/h
(mm)
128 286
104 181
76 95
20
17
25
GB
11